






The Plumes® Jr MOSFET Mod – a limited edition of our “Small Signal Shredder” – reimagines the original Plumes® in a smaller format, ideal for pedalboards. Like the original model, this compact pedal offers a “tube-style” overdrive with three distinct clipping modes, but with one major difference: the third mode (indicated by “M”) has been replaced by a new MOSFET clipping mode. This mode produces a rich, well-defined overdrive with more bass and a dynamic response comparable to that of a modern high-gain tube amp.
Mode L
Symmetrical clipping using a pair of light-emitting diodes (LEDs). This is the crunchiest setting available on the Plumes.
Mode N
“Clean boost” mode. Here, the clipping diodes are completely bypassed, leaving only pure saturation from the operational amplifier (OpAmp). It is the ideal tool for highlighting your clean tone or pushing the preamp of an already saturated amp into rich, musical distortion.
Mode M
We have replaced the silicon diode asymmetrical configuration—similar to that found in classic “Screamer” style pedals—with a MOSFET clipping mode. The result is a bold, open, and smooth overdrive, rich in harmonics, with bite reminiscent of a tube amp pushed to its limits.
Clipping modes (3-way selector):
L: Symmetrical LED clipping – Crunchy, compressed, mid-focused, and precise.
N: No clipping – Direct saturation via the operational amplifier (OpAmp) for a “clean boost.”
M: MOSFET clipping – Rich in harmonics and well-defined, with more bass and dynamics similar to those of a modern high-gain tube amp.
Level: Controls the output volume.
Gain: Controls the amount of saturation.
Tone: More bass to the left, more mids in the center, and more treble to the right.
Power consumption
25 mA
Input impedance
10 MΩ
Output impedance
100 Ω
Switching
This device uses a traditional mechanical true bypass system. Power supply
This device requires a standard 9V DC power supply with a 2.1 mm center-negative cylindrical jack. We always recommend using pedal-specific mains power supplies with transformer isolation or power supplies with multiple isolated outputs. Pedals can generate noise in the event of ripple or unstable voltage. Switching power supplies, series power supplies, and non-pedal-specific power supplies filter interference less effectively and allow unwanted noise to pass through. DO NOT USE A HIGHER VOLTAGE!